How To Save Money On Fiat 500 Replacement Key Cost
Fiat 500 Replacement Key Fob
If your 500 remote key fob isn't working, it's time to replace the battery. If you do replace the battery but it is still not working, then the problem could be elsewhere.
United Locksmith specializes in the creation of new keys for classic vehicles. We have all the tools and accessories needed to provide this service.
Dead Coin Battery
A dead battery is the main cause of your Fiat 500 keyfob not locking or unlocking the doors. The key fob has an internal battery called a coin cell that can quickly deplete in the event that it is not utilized frequently enough. If your remote began to show signs of weakening such as a loss of range and stopped working completely The battery is probably dead.
Metal clips hold the battery securely inside the key fob. If the clips are not tightly secured, they could result in problems with the contact, which can stop your remote from receiving power. Make use of a flathead screwdriver to break open the retaining clip and then remove the old battery. Use TheKeyLab that has the same voltage, size, and specification as the original.
The key fob can also become corroded or damaged through exposure to water. Even a short bath in soapy water can harm the electronic chip within. Make sure your key fob is dry.
Water Damage
Water damage could be the reason for your key fob's not functioning properly. Key fobs are fitted with rubber seals that stop them from being damaged by rain or a splash of water, however it is essential to keep your keys away from the pool, ocean and the washing machine!
The key fob is equipped with an electronic chip inside that transmits a signal to your car's immobilizer system. The chip allows the 500 to start and lock. If it gets wet, however it will not work.
If you're trying to determine whether your key fob functioning You can clean the internal electronics with isopropyl or an electronic cleaner. It is recommended to replace a key fob if it's submerged in salt water instead of trying to repair it yourself.
While a replacement fob can cost you a bit of money, it is much cheaper than paying for your Fiat 500 to be towed to the dealer for repair! You can also do it yourself with a few simple steps. Make sure you have the correct type of battery prior to opening your keyfob. This task is much simpler than it appears, and you can find step-by-step directions online for virtually any key fob for your car.
Faulty Chip
The chip in the key fob connects directly with the immobiliser on your car to ensure that your vehicle will only start once the correct keys are inserted. If the chip is damaged or damaged in any way it will not start.
A damaged chip could occur due to many reasons, but most commonly due to water damage or an unresponsive battery. It is best to delegate the job to a professional locksmith, who can replace the chip quickly and at reasonable cost.
If your key fob will not work after exposure to clean water from a tap or rain take it off the battery. Clean the electronic component using paper towels. If the key fob does not work it's most likely a fried chip and must be replaced.
Some people will go to their dealer when in need of a new Fiat key fob, but this is a expensive option. United Locksmith is the best place to go if you are looking to have your Fiat key fob repaired at a reasonable price. We have the tools and knowledge required to repair your Fiat fob in a timely and professional way.
Faulty Receiver Module
Fiat key fobs send a signal up 50 feet away to the vehicle, which can unlock and lock the doors (and start the vehicle for vehicles with automatic transmissions). However, there are a few factors that can cause the fob to stop functioning. This could be due to a dead battery or water damage, worn out buttons as well as a receiver issue. signal interference, or malfunctioning chips.
If the fob was in a pocket which has suffered a severe trauma, such as being dropped on hard floor or getting washed in the washing machine the fob may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept a signal from a genuine original key and not any other.
If this is the case, you have to replace your fob. A professional locksmith will handle the entire key replacement process including programming a new key for your 500. They can even give you an clone fob that performs the same as the original (and costs less than what it would cost).